About our metal finishing shop in Utah

Dozti Metal is a small finishing and restoration shop in Iron County. We spend our days on the surface of metal: cleaning it, grinding it, softening its edges and bringing it up to a finish.

A shop built around finishing

Plenty of shops cut and form metal. Fewer give the surface their full attention. That is the part of the job we chose. Our benches are set up for wire brushing, grinding, deburring and polishing, with separate abrasives for stainless and carbon steel and plenty of room to lay out a batch and see it in good light.

Because finishing is all we do, we can talk about it in plain terms. You do not need to know abrasive grades or wheel types. Tell us how the part is used, who sees it and what comes next, and we will suggest where on the finish ladder it should stop.

How we like to work

Every job starts with looking: at your drawing, your photos or a sample. We ask questions before we quote, because a short conversation saves a lot of rework. The quote comes in writing, and on batches the first finished piece comes to you for approval before the rest are done.

We keep parts in order, keep finished faces apart, and wrap work so it arrives clean. When something about a part worries us, we call before we carry on.

Repeat customers get the same care on the tenth batch as on the first. We keep a short note for each repeat part with the approved finish, the edge break and anything special about handling, so the next run matches the last one without you having to explain it again.

Finishing corner of a small shop with a bench grinder, belt sander, downdraft table and racks of bar stock and sheet

Our habits

  1. Look first

    We read the surface and ask questions before we quote.

  2. Write it down

    Scope, finish and critical sizes go into a written quote.

  3. Show one

    On batches, the first finished piece comes to you before the rest.

  4. Pack with care

    Finished faces kept apart, wrapped and boxed.

Where we work

Our shop is in Iron County, and most of our customers are businesses in Iron County and nearby Washington County communities. Parts can be dropped off during opening hours or shipped to us, and they are always finished in our shop.

We are open Monday to Friday, 7:30 AM to 6:00 PM, and closed on weekends. Calls and emails that come in after hours are answered on the next working day.

Want to talk through a part?

Call during opening hours or send the form with a few photos. We are happy to suggest where on the ladder a part should stop.