Metal Polishing in Utah
We polish metal parts to the finish you choose, from an even brushed satin to a bright mirror, on steel, stainless steel, aluminum and brass.
- As received
- Cleaned
- Ground
- Deburred
- Polished

Polishing is the top rung of the finish ladder. It is where a part goes from looking made to looking finished. Covers, trim, handles, plates, signage blanks, decorative pieces and display parts usually end up here, because people look at them and touch them every day.
Good polishing starts lower down the ladder. A part with scratches, dents or burrs will show every one of them once it is bright, so we make sure the surface is ground and deburred properly first. Then we work up through finer abrasives on belts and wheels, and finish with buffing compound on cloth wheels for a bright result or a fine non-woven wheel for a satin grain.
Finishes we polish to
Brushed or satin
A soft, even grain running in one direction. It hides fingerprints and small marks well and suits panels, covers and trim.
Bright polish
A smooth, shiny face that still shows a faint softness. A good everyday choice for handles, knobs and hardware.
Mirror
A deep reflective finish with no visible lines. It takes the most steps and suits decorative and display pieces.
Matching an existing part
Send a part you like and we will match its grain and brightness as closely as we can on the new ones.
Parts we usually see
- Stainless covers, plates and trim
- Aluminum panels and machined parts
- Brass and steel hardware
- Signage and nameplate blanks
- Decorative pieces for shops and studios
- Restored parts getting a new face
What to send
- Material: steel, stainless steel, aluminum or brass
- The finish you want, or a sample to match
- Which faces are seen and which are hidden
- Quantity and part size
How the job runs
Choose the finish
Tell us the finish in words or send a sample. The finish guide can help with the words.
Written quote
We check the starting surface and the steps needed, and send a written quote before work begins.
First piece
We polish one part first so you can see the finish in your hand and approve it.
Wrap and protect
Polished parts are wiped, wrapped individually and boxed so the faces arrive as they left the wheel.
What people ask about metal polishing
Which finish hides fingerprints well?
A brushed or satin finish hides fingerprints and light scratches far better than mirror. For parts that get handled all day, it is usually the practical choice.
Can you polish aluminum to a mirror?
Yes. Aluminum polishes up very bright, but it is soft and dulls faster in daily use than stainless. We can talk through what suits the part.
Do you polish only the visible faces?
If you tell us which faces show once the part is fitted, we can polish those and leave hidden faces with a cleaner, simpler finish.
How do we keep a polished part looking good?
Wipe it with a soft cloth and mild soapy water, dry it, and avoid scouring pads. The finish guide has more on care.
Ask about polishing
Send the metal, the quantity and a few photos or a drawing. We review it and reply with questions or a written quote.