Surface work

Metal Deburring in Utah

We remove burrs and sharp edges from cut, punched, drilled and machined metal parts, so they handle safely, fit cleanly and look finished.

  1. As received
  2. Cleaned
  3. Ground
  4. Deburred
  5. Polished
Gloved hand using a hand deburring tool on the edge of a laser-cut aluminum plate with holes and slots

Almost every cutting process leaves a burr: a thin ragged lip of metal on the edge of a laser-cut blank, around a drilled hole, along a sheared edge or at the end of a machined slot. Burrs cut fingers, scratch mating parts, tear gaskets and wiring, and keep parts from sitting flat in an assembly. Deburring is the rung of the ladder that deals with them.

Dozti Metal deburrs by hand and at the bench. Swivel-blade deburring tools, countersinks, files, abrasive belts and non-woven wheels let us match the method to the part. Small runs of delicate parts get hand work; flat blanks with long straight edges can go across a belt or wheel for an even, repeatable edge.

What deburring covers

  • Outside edges

    Burrs removed from laser-cut, sheared and sawn edges, with a light break or a small round so the edge is smooth to the touch.

  • Holes and slots

    Entry and exit burrs on drilled and punched holes cleaned up with countersinks and hand tools, inside slots and cutouts as well.

  • Machined features

    Burrs at the ends of milled slots, thread starts and cross holes removed without touching the surfaces around them.

  • Even face grain

    Where you want it, the faces of flat parts get an even satin grain at the same time, so the whole part looks consistent.

Parts we usually see

  • Laser-cut aluminum and steel plates
  • Punched and drilled brackets
  • Sheet metal covers and enclosure parts
  • Machined spacers, blocks and plates
  • Small batches of prototype parts
  • Repeat runs from local manufacturers

What to send

  • Drawing or clear photos of both sides
  • Material and thickness
  • Quantity and how often the part repeats
  • The edge you want, in plain words

How the job runs

  1. Tell us the edge

    A drawing or a sample, plus how much edge break you want: just remove the burr, a light break, or a visible small round.

  2. Written quote

    We look at the number of edges and holes per part and the quantity, and send a written quote.

  3. First piece

    One part is deburred and set aside for your approval before the batch.

  4. Count and pack

    Finished parts are counted, kept apart so edges stay clean and packed for you to collect.

What people ask about metal deburring

How do I describe the edge I want?

Plain words work well: remove the burr only, a light edge break, or a small round you can see. If you have a part you like, send it and we will match it. Exact edge sizes are confirmed in the quote.

Can you deburr parts from our laser or punch?

Yes. Many of the parts we see come straight off a laser or punch at another shop or at your plant. Send them in the boxes they ship in and we keep them in order.

Do you deburr small, delicate parts?

Yes. Small or thin parts are done by hand so they do not bend or get marked by a machine.

Will deburring mark the faces?

We take care to keep faces clean. If faces are already finished, tell us and we protect them during the work.

Ask about deburring

Send the metal, the quantity and a few photos or a drawing. We review it and reply with questions or a written quote.