Surface work

Metal Surface Preparation in Utah

We take metal parts from as received to clean, sound metal by mechanical means, ready for your painter, your coater or the next step in our shop.

  1. As received
  2. Cleaned
  3. Ground
  4. Deburred
  5. Polished
Steel plate with mill scale on one half and mechanically cleaned bright steel on the other, next to a flap disc and gloves

Most parts that come through the door carry something on the surface that has to go before anything else can happen: mill scale from the steel mill, a film of light rust from storage, old paint that has started to lift, or the dull grey skin left on laser-cut blanks. Surface preparation is the first rung of the finish ladder, and it decides how well every later step works.

At Dozti Metal this work is done by hand and with bench machines in our shop. We use wire wheels, flap discs, abrasive belts, non-woven pads and hand tools, chosen for the part and the metal. The goal is simple: clean metal, an even surface texture, and no damage to edges, holes or features that matter to you.

What surface preparation covers

  • Mill scale and storage rust

    Hot-rolled steel arrives with a blue-grey scale, and parts that have sat in a yard or a back room often pick up a thin orange film. We take both down to bright grey steel with abrasives sized so the surface stays flat.

  • Old, failing finish

    Paint that has chipped or flaked on a guard, cover or fixture is removed mechanically, with care around edges, threads and hardware holes.

  • A profile for your coating

    Paint and powder coat need a clean surface with a little tooth. We leave an even scratch pattern, which you can describe as light, medium or heavy, so your coater gets what they expect.

  • Ready for the next rung

    Many parts move straight on to grinding, deburring or polishing here. Preparation done well makes those steps faster and cleaner.

Parts we usually see

  • Laser-cut and sheared steel blanks
  • Brackets, plates and mounting hardware
  • Equipment covers, guards and panels
  • Shop fixtures and display frames
  • Older parts heading for refinishing
  • Aluminum and stainless parts with handling marks

What to send

  • Material and rough size of the parts
  • How many pieces, and whether this is a repeat run
  • What happens next: paint, powder coat, assembly or our polishing
  • Any faces, threads or holes that must stay untouched

How the job runs

  1. Photos or a sample

    Send a few clear photos, a sample piece or a drawing, plus the finish your coater or assembler needs.

  2. Written quote

    We look at the metal, the amount of scale or old finish and the quantity, then send a written quote before any work starts.

  3. First piece

    On a batch, we prepare one part first so you or your coater can approve the surface.

  4. The batch

    The rest of the parts follow the approved piece, then they are wrapped dry and set out for you to collect.

What people ask about metal surface preparation

What surface do you leave for powder coat or paint?

A clean, dry surface with an even scratch pattern. Ask your coater whether they want a light, medium or heavy profile and we work to that, finishing with a dry wipe so the part is clean when it leaves the bench.

How soon should prepared steel be painted or coated?

Bare steel starts to pick up surface rust when it meets moist air, so plan for your coater to see the parts soon after you collect them. We wrap prepared parts dry to help in the meantime.

Can you prepare only part of a surface?

Yes. Tell us which faces to prepare and which to leave alone. We mask or simply work around areas such as machined faces and threaded holes.

Do you prepare aluminum and stainless too?

Yes. Aluminum and stainless do not carry mill scale, but they often need handling marks, light scratches or old finish removed before polishing or coating.

Ask about surface preparation

Send the metal, the quantity and a few photos or a drawing. We review it and reply with questions or a written quote.